CP_a038 — Latch Not Blocking

Full alert identifier: CP_a038_latchNotBlocking

Alert description

The charge port (CP) electronic control unit (ECU) detects that the latch is not in the blocking position when it is expected to be.

Potential impact

The latch does not block cable insertion when it is expected to.

Set condition

The latch position sensor indicates that the latch is disengaged after the CP attempts to engage the latch fully, or if the latch is expected to be blocking cable insertion.

Clear condition

The CP ECU detects that the latch enters the blocking state.

Signals to check

Open this alert in Service Mode Plus and review the Payload tab. Use the field names below to identify the values shown by your vehicle.

Signal	Unit
CP Aps Voltage `CP_a038_CP_apsVoltage`	V
Latch Counts Filtered `CP_a038_latchCountsFiltered`	%

Signal	Unit
CHG Insert Enable `CP_a038_CHG_InsertEnable`	—
CP Latch Enable Cmd `CP_a038_CP_latchEnableCmd`	—
Inlet ID `CP_a038_inletID` 0 SAE 1 IEC 2 GBAC 3 GBDC 4 MCS	—
Latch State `CP_a038_latchState` 0 SNA 1 DISENGAGED 2 ENGAGED 3 BLOCKING	—

Check other alerts

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of CP_a038.