Vehicle security controller alerts

VCSEC alert codes

Showing 201–250 of 332

• VCSEC_a271 — T PMS Hard Warning Front Right VCSEC_a271_TPMSHardWarningFrontRight Front right tire may be flat
• VCSEC_a272 — T PMS Hard Warning Rear Left VCSEC_a272_TPMSHardWarningRearLeft Rear left tire may be flat
• VCSEC_a273 — T PMS Hard Warning Rear Right VCSEC_a273_TPMSHardWarningRearRight Rear right tire may be flat
• VCSEC_a274 — Handle Pull Without Auth2 VCSEC_a274_handlePullWithoutAuth2 Extra BLE metadata for when a door handle was pulled without an authenticated device.
• VCSEC_a275 — Child Seat Not Connected At Start Of Drive VCSEC_a275_childSeatNotConnectedAtStartOfDrive Paired child seat not connected through BLE at start of drive
• VCSEC_a276 — Child Seat Not Connected At End Of Drive VCSEC_a276_childSeatNotConnectedAtEndOfDrive Paired child seat not connected through BLE at the end of drive
• VCSEC_a277 — Child Seat Battery Is Low VCSEC_a277_childSeatBatteryIsLow Child seat battery is low. Need to replace battery for child seat
• VCSEC_a280 — T PMS Low Battery0 VCSEC_a280_TPMSLowBattery0 The Tire Pressure Monitoring System (TPMS) sensor 0 has low battery voltage.
• VCSEC_a281 — T PMS Low Battery1 VCSEC_a281_TPMSLowBattery1 The Tire Pressure Monitoring System (TPMS) sensor 1 has low battery voltage.
• VCSEC_a282 — T PMS Low Battery2 VCSEC_a282_TPMSLowBattery2 The Tire Pressure Monitoring System (TPMS) sensor 2 has low battery voltage.
• VCSEC_a283 — T PMS Low Battery3 VCSEC_a283_TPMSLowBattery3 The Tire Pressure Monitoring System (TPMS) sensor 3 has low battery voltage.
• VCSEC_a300 — Schedule It Key Added VCSEC_a300_scheduleItKeyAdded Added scheduleit key. Enrolled into scheduleit fleet
• VCSEC_a301 — Imposter Detected VCSEC_a301_imposterDetected VCSEC heard itself being impersonated
• VCSEC_a302 — Unfused VCSEC_a302_unfused Security Vehicle Controller (VCSEC) is using the factory key (unfused) rather than a production key (fused).
• VCSEC_a303 — Keyfob Update Interrupted VCSEC_a303_KeyfobUpdateInterrupted Security controller could not update a keyfob but may try again
• VCSEC_a304 — Keyfob Update Complete VCSEC_a304_KeyfobUpdateComplete Security controller has successfully updated a keyfob
• VCSEC_a305 — ATT Flow Control Violated C VCSEC_a305_ATTFlowControlViolatedC An ATT flow control violation was encountered on one of the connections
• VCSEC_a306 — Keyfob Adv Received While Connected VCSEC_a306_KeyfobAdvReceivedWhileConnected Keyfob connection has been dropped since an advertisement was received from the connected keyfob
• VCSEC_a307 — ATT Timeout VCSEC_a307_ATTTimeout Connection has been dropped due to an ATT Timeout
• VCSEC_a308 — Non Connectable Adv Received VCSEC_a308_NonConnectableAdvReceived A non-connectable advertisement was recived from a keyfob
• VCSEC_a309 — Service Key Conditions Not Met VCSEC_a309_serviceKeyConditionsNotMet A protobuf signed by the service key has been declined. Enable Service access mode if service is being performed
• VCSEC_a310 — Charge Port Filter False Positive VCSEC_a310_chargePortFilterFalsePositive The Vehicle Security Controller (VSEC) detected that the Ultra-High Frequency (UHF) or Bluetooth Low Energe (BLE) chargeport open command from the charge handle was falsely filtered.
• VCSEC_a310 — Uhf Charge Port Filter False Positive VCSEC_a310_uhfChargePortFilterFalsePositive False positive filtering of incoming UHF chargePort open signal
• VCSEC_a311 — More Than Three Keys Present VCSEC_a311_moreThanThreeKeysPresent Extra key detected with BLE keyfob press
• VCSEC_a312 — Unexpected BLE Disconnect VCSEC_a312_unexpectedBLEDisconnect A device that was at high levels of RSSI disconnected. This is not expected behavior for a device
• VCSEC_a315 — Ble Bonding Event VCSEC_a315_bleBondingEvent Something of note has happened to the BLE pairing state of a device.
• VCSEC_a316 — Ltk Request Rejected VCSEC_a316_ltkRequestRejected VCSEC has rejected an LTK request.
• VCSEC_a401 — Rear Left Endpoint Lost Comm VCSEC_a401_rearLeftEndpointLostComm The Security Controller (VCSEC) has not detected signal from the rear left Bluetooth Low Energy (BLE) endpoint for over ten seconds.
• VCSEC_a402 — Rear Right Endpoint Lost Comm VCSEC_a402_rearRightEndpointLostComm The security controller did not receive event for more than 10sec from the endpoint
• VCSEC_a404 — N FC Cradle Endpoint Lost Comm VCSEC_a404_NFCCradleEndpointLostComm The Security Controller (VCSEC) has not detected signal from the wireless charger Near Field Communication (NFC) reader for over ten seconds.
• VCSEC_a406 — Hci Debug RL VCSEC_a406_hciDebugRL There was an issue receiving an HCI event
• VCSEC_a407 — Hci Debug RR VCSEC_a407_hciDebugRR There was an issue receiving an HCI event
• VCSEC_a408 — Hci Debug NF CC VCSEC_a408_hciDebugNFCC There was an issue receiving an HCI event
• VCSEC_a411 — Left Rear Endpoint Busy VCSEC_a411_leftRearEndpointBusy The security controller missed an event from the endpoint BLE chip
• VCSEC_a412 — Right Rear Endpoint Busy VCSEC_a412_rightRearEndpointBusy The security controller missed an event from the endpoint BLE chip
• VCSEC_a413 — N FC Cradle Endpoint Busy VCSEC_a413_NFCCradleEndpointBusy The security controller missed an event from the endpoint BLE chip
• VCSEC_a416 — BLE Cradle N FC Soft Reset VCSEC_a416_BLECradleNFCSoftReset BLE NFC Cradle endpoint soft reset
• VCSEC_a417 — BLE Rear Left Soft Reset VCSEC_a417_BLERearLeftSoftReset BLE Rear Left endpoint soft reset
• VCSEC_a418 — BLE Rear Right Soft Reset VCSEC_a418_BLERearRightSoftReset BLE Rear Right endpoint soft reset
• VCSEC_a420 — BLE Unexpected Reset N FC Cradle VCSEC_a420_BLEUnexpectedResetNFCCradle BLE endpoint unexpected reset
• VCSEC_a421 — BLE Unexpected Reset RL VCSEC_a421_BLEUnexpectedResetRL BLE endpoint unexpected reset
• VCSEC_a422 — BLE Unexpected Reset RR VCSEC_a422_BLEUnexpectedResetRR BLE endpoint unexpected reset
• VCSEC_a425 — BLEN FC Cradle Assert Failure VCSEC_a425_BLENFCCradleAssertFailure The NFC Cradle endpoint failed assert caused by an error in the TI stack
• VCSEC_a426 — BLE Rear Left Assert Failure VCSEC_a426_BLERearLeftAssertFailure The Rear Left endpoint failed assert caused by an error in the TI stack
• VCSEC_a427 — BLE Rear Right Assert Failure VCSEC_a427_BLERearRightAssertFailure The Rear Right endpoint failed assert caused by an error in the TI stack
• VCSEC_a428 — UWB Center Update Interrupted VCSEC_a428_UWBCenterUpdateInterrupted Security controller could not update UWB A-header but may try again
• VCSEC_a429 — UWB Left Update Interrupted VCSEC_a429_UWBLeftUpdateInterrupted Security controller could not update UWB Left but may try again
• VCSEC_a430 — UWB Right Update Interrupted VCSEC_a430_UWBRightUpdateInterrupted Security controller could not update UWB Right but may try again
• VCSEC_a432 — UWB Rear Left Update Interrupted VCSEC_a432_UWBRearLeftUpdateInterrupted Security controller could not update UWB Rear Left but may try again
• VCSEC_a433 — UWB Rear Right Update Interrupted VCSEC_a433_UWBRearRightUpdateInterrupted Security controller could not update UWB Rear Right but may try again