VCSEAT2R_a245 — Seat Armrest Ecu Log Status
Full alert identifier: VCSEAT2R_a245_seatArmrestEcuLogStatus
Alert description
Diagnostic snapshot of the 2nd row seat armrest ECU log capture/upload mechanism, emitted whenever any reported field changes. loggingState is the raw upload-framework state: LOGGING (collecting), OFFERED (buffer advertised for pull), UPLOADING (tester is pulling), or UPLOADED (transfer just completed). entryCount (saturating 0-15) and bufferUsedBytes are the movement-entry count and used byte count of the resident append-only buffer (an upload does not clear the buffer in normal operation). pendingUpload indicates the buffer holds committed data not yet uploaded. bufferFull is set when a finalized entry could not be stored because the buffer is full (entries are never evicted), and awayLock is set once the vehicle has been parked/locked (power state at/below CONDITIONING) for at least 10 seconds; both are reported so the CID campaign can decide when to issue the dynamic upload trigger. discardedCount is a saturating (0-15) count of movements dropped while no space was available to store them (buffer full, or buffer locked for an in-progress upload). ecuLogUID is the low 16 bits of the buffer/log session id (generated with the buffer, stable until it is cleared), so alerts from one session share the same value; the full 32-bit id is recorded in the uploaded log blob header.
Potential impact
This information is not available in the alert reference.
Set condition
This information is not available in the alert reference.
Clear condition
This information is not available in the alert reference.
Check other alerts
With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of VCSEAT2R_a245.