EPBL_a262 — Cannot Prepare Winch Mode
Full alert identifier: EPBL_a262_cannotPrepareWinchMode
Alert description
Non user facing alert set when user attempts to enter winch mode but a system reason prevents EPB from activating winch mode
Potential impact
This information is not available in the alert reference.
Set condition
This information is not available in the alert reference.
Clear condition
This information is not available in the alert reference.
Signals to check
These diagnostic fields are associated with EPBL_a262. Check the alert's Payload in Service Mode Plus for available values.
| Signal | Unit |
|---|---|
Brake Not Confirmed Pressed
EPBL_
|
— |
Charge Cable Definitely Attached
EPBL_
|
— |
Charge Cable Potentially Attached
EPBL_
|
— |
Charge Cable State Unknown
EPBL_
|
— |
Dir LV On
EPBL_
|
— |
Hv Down For More Than Two Minutes
EPBL_
|
— |
Hv Up
EPBL_
|
— |
Ignore Lv Battery Can Support Vehicle
EPBL_
|
— |
Show 11 more fields
| Signal | Unit |
|---|---|
Input Voltage Too Low
EPBL_
|
— |
Lv Battery Blocking
EPBL_
|
— |
Lv Battery Can Support Vehicle
EPBL_
|
— |
Not Secure
EPBL_
|
— |
Not Stopped
EPBL_
|
— |
Showroom Mode Active
EPBL_
|
— |
Ui Service Mode
EPBL_
|
— |
Ui Service Mode Plus
EPBL_
|
— |
User Confirmed Charge Cable Not Attached
EPBL_
|
— |
Vcfront MIA
EPBL_
|
— |
Was HV Up Since Last Wake
EPBL_
|
— |
Check other alerts
With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of EPBL_a262.