Model Y

EPASTS_a153 — Sdsm Block Selector Invalid

Full alert identifier: EPASTS_a153_sdsmBlockSelectorInvalid

Alert description

This alert is reported by the StreamingDataStorageManager_R12 (SDSM) component when the requested BlockId for the streaming data store is invalid. Fast restart related feature.

Potential impact

EPAS fast restart was not possible.

Set condition

Requested BlockId for the streaming data store is invalid.

Clear condition

Perform EPAS Software update. Replace HW if the alert persists.

Signals to check

These diagnostic fields are associated with EPASTS_a153. Check the alert's Payload in Service Mode Plus for available values.

Signal	Unit
Debug Info `EPASTS_a153_debugInfo`	—

Check other alerts

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of EPASTS_a153.

EPASTS_a155 — Sdsm Data Invalid All EPASTS_a155_sdsmDataInvalidAll This alert is reported by the StreamingDataStorageManager_R12 (SDSM) component when the CRC is not equal to saved CRC value in all memory blocks.
EPASTS_a154 — Sdsm Cs Error Invalid Primary EPASTS_a154_sdsmCsErrorInvalidPrimary This alert is reported by the StreamingDataStorageManager_R12 (SDSM) component when the CRC is not equal to saved CRC value at any memory block, but another is correct
EPASTS_a197 — Difp Difactor Invalid EPASTS_a197_difpDifactorInvalid This alert is reported by the DIFactorProvider_Generic (DIFP) component in case of DI factor Calibration data failure.
EPASTS_a003 — Psp Invalid Paramset EPASTS_a003_pspInvalidParamset This alert is reported by the ParameterSelectorProvider_R12 (PSP) component when Powerpack (PWP), Common (COM), or ECU parameter selection is not successful.
EPASTS_a157 — Mcudcp Invalid Ecu Id EPASTS_a157_mcudcpInvalidEcuId This alert is reported by the reported by the MCUDynamicConfigurationProvider_TC3x component when reading EndOfLine ECU parameters fails.

Browse all EPASTS alert codes