DPB_a130 — Asic Malfunction Detected
Full alert identifier: DPB_a130_AsicMalfunctionDetected
Alert description
On the system ASIC an overcurrent event occured. The General Purpose Input Output (GPIO) is not operating as expected.
Potential impact
System will be running in fully degraded state. Braking may require increased effort. Hydraulic Boost Compensation will be triggered when driver pressed brake pedal.
Set condition
This fault will be reported if the GPIO is switched off but the overcurrent bit of the ASIC remains set (GPIO is not operating as expected).
Clear condition
No internal issue is detected after changing operation cycle. If the condition persists, the DPB module may require replacement.
Check other alerts
With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of DPB_a130.