Vehicle gateway alerts

GTW alert codes

Showing 201–250 of 257

• GTW_w326 — Mcu Uv Prot Slf Tst Without Soc Rsp GTW_w326_mcuUvProtSlfTstWithoutSocRsp The vehicle Gateway (GTW) waits for the Media Control Unit (MCU) to give it a go ahead to perform the undervoltage protection self test. But since the GTW did not get a response within the expected time, it is proceeding with the self tes…
• GTW_w327 — Mcu Uv Prot Slf Tst Precod Violated GTW_w327_mcuUvProtSlfTstPrecodViolated The vehicle Gateway (GTW) needs full control over discrete Graphics Processing Unit (dGPU) and the undervoltage arming circuit before it can run the self test. However, it detects that hardware is not in the correct configuration.
• GTW_w328 — Smart Shift Disabled GTW_w328_smartShiftDisabled Smart shift is disabled because of unhealthy checking or user settings.
• GTW_w329 — FOHM version Mismatch GTW_w329_FOHMversionMismatch The vehicle gateway (GTW) detects the Front Overhead Module (FOHM) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.
• GTW_w330 — SWSL version Mismatch GTW_w330_SWSLversionMismatch The vehicle gateway (GTW) detects the left Steering Wheel Switchpack (SWSL) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.
• GTW_w331 — SWSR version Mismatch GTW_w331_SWSRversionMismatch The vehicle gateway (GTW) detects the right Steering Wheel Switchpack (SWSR) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.
• GTW_w332 — Unknown Display PN GTW_w332_unknownDisplayPN Find a Unknown DisplayPN or failed to read DisplayPN when read DisplayPN
• GTW_w333 — Ethloop Switch Port1 Link Down GTW_w333_ethloopSwitchPort1LinkDown The vehicle Gateway (GTW) detects port 1 of the etherloop switch has a link down, indicating a condition affecting the cabling or the High Voltage Controller (HVC) connected to port 1.
• GTW_w334 — Hrl Folder Space Low GTW_w334_hrlFolderSpaceLow The vehicle Gateway (GTW) detected file system has insufficient disk space for storing continuous and event triggered High Resolution Log (HRL) files.
• GTW_w336 — Possible Can Tx Issue GTW_w336_possibleCanTxIssue An issue has been detected in GTW CAN Tx
• GTW_w337 — Etherloop Switch Congested GTW_w337_etherloopSwitchCongested The vehicle Gateway (GTW) detects that the etherloop switch has started to become congested
• GTW_w338 — VCBLDCB version Mismatch GTW_w338_VCBLDCBversionMismatch The vehicle gateway (GTW) detects the Blower Controller (VCBLDCB) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.
• GTW_w339 — VCBLDCFL version Mismatch GTW_w339_VCBLDCFLversionMismatch The vehicle gateway (GTW) detects the Left Fan Controller (VCBLDCFL) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.
• GTW_w340 — VCBLDCFR version Mismatch GTW_w340_VCBLDCFRversionMismatch The vehicle gateway (GTW) detects the Right Fan Controller (VCBLDCFR) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.
• GTW_w341 — VCBLDCPC version Mismatch GTW_w341_VCBLDCPCversionMismatch The vehicle gateway (GTW) detects the Chiller Pump Controller (VCBLDCPC) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.
• GTW_w342 — VCBLDCPP version Mismatch GTW_w342_VCBLDCPPversionMismatch The vehicle gateway (GTW) detects the Powertrain Pump Controller (VCBLDCPP) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.
• GTW_w343 — Etherloop Init Failed GTW_w343_etherloopInitFailed The vehicle Gateway (GTW) was unable to initialize its etherloop subsystem. The alert payload contains the failure reason code.
• GTW_w344 — Etherloop Switch Watchdog GTW_w344_etherloopSwitchWatchdog The vehicle Gateway (GTW) has detected an issue with the etherloop switch, which may not be receiving or transmitting data, and will reset it. The alert payload contains the watchdog reason code.
• GTW_w345 — Etherloop Switch Reset Failed GTW_w345_etherloopSwitchResetFailed The vehicle Gateway (GTW) tried to reset the etherloop switch but failed.
• GTW_w346 — Etherloop Switch Reset Skip Snoop GTW_w346_etherloopSwitchResetSkipSnoop The vehicle Gateway (GTW) skipped resetting the etherloop switch as the ethersnooper port was connected.
• GTW_w347 — Etherloop Switch Slow Data Rate GTW_w347_etherloopSwitchSlowDataRate The vehicle Gateway (GTW) detected that its Etherloop switch is not receiving data at the expected rate from other vehicle systems, including the drive system and steering system, starting with the Autopilot Processor Primary (APP) and the…
• GTW_w350 — M OSD Crc Check GTW_w350_mOSDCrcCheck Unexpected CRC matches/mismatches.
• GTW_w351 — S OSD Crc Check GTW_w351_sOSDCrcCheck Unexpected CRC matches/mismatches.
• GTW_w352 — M ASIL Status Check GTW_w352_mASILStatusCheck Check if any of the bits are set or not
• GTW_w353 — S ASIL Status Check GTW_w353_sASILStatusCheck Check if any of the status bits are set or not
• GTW_w356 — Touch GPIO Status Check GTW_w356_touchGPIOStatusCheck Determine the reason for TCON reset caused by touch/gpio errors
• GTW_w357 — Mcu Uv Prot Cant Unlatch GTW_w357_mcuUvProtCantUnlatch The vehicle Gateway (GTW) unsuccessfully attempted to disengage the undervoltage protection loadshed circuit. May indicate the Media Control Unit (MCU) was engaging the loadshed circuit when GTW was trying to disengage it.
• GTW_w358 — RGBIPFL version Mismatch GTW_w358_RGBIPFLversionMismatch The vehicle gateway (GTW) detects the Red Green Blue light in the front left Instrument Panel (RGBIPFL) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the v…
• GTW_w359 — RGBIPFR version Mismatch GTW_w359_RGBIPFRversionMismatch The vehicle gateway (GTW) detects the Red Green Blue light in the front right Instrument Panel (RGBIPFR) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the…
• GTW_w364 — BLEEPCRADLE version Mismatch GTW_w364_BLEEPCRADLEversionMismatch The vehicle gateway (GTW) detects the Bluetooth Low Energy End Point Phone Cradle (BLEEPCRADLE) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.
• GTW_w365 — Etherloop Switch Disable Snoop Failed GTW_w365_etherloopSwitchDisableSnoopFailed Etherloop switch failed to disable ethersnooper port
• GTW_w366 — Ui Gear Request Mismatch GTW_w366_uiGearRequestMismatch The Gateway (GTW) detects a gear request from the User Interface that does not match the corresponding gesture processed by the GTW
• GTW_w368 — RGBFLFORE version Mismatch GTW_w368_RGBFLFOREversionMismatch The vehicle gateway (GTW) detects the Red Green Blue light in the front left fore (RGBFLFORE) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.
• GTW_w369 — RGBFLAFT version Mismatch GTW_w369_RGBFLAFTversionMismatch The vehicle gateway (GTW) detects the Red Green Blue light in the front left aft (RGBFLAFT) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.
• GTW_w370 — RGBRLFORE version Mismatch GTW_w370_RGBRLFOREversionMismatch The vehicle gateway (GTW) detects the Red Green Blue light in the rear left fore (RGBRLFORE) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.
• GTW_w371 — RGBRLAFT version Mismatch GTW_w371_RGBRLAFTversionMismatch The vehicle gateway (GTW) detects the Red Green Blue light in the rear left aft (RGBRLAFT) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.
• GTW_w372 — RGBFRFORE version Mismatch GTW_w372_RGBFRFOREversionMismatch The vehicle gateway (GTW) detects the Red Green Blue light in the front right fore (RGBFRFORE) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.
• GTW_w373 — RGBFRAFT version Mismatch GTW_w373_RGBFRAFTversionMismatch The vehicle gateway (GTW) detects the Red Green Blue light in the front right aft (RGBFRAFT) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.
• GTW_w374 — RGBRRFORE version Mismatch GTW_w374_RGBRRFOREversionMismatch The vehicle gateway (GTW) detects the Red Green Blue light in the rear right fore (RGBRRFORE) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.
• GTW_w375 — RGBRRAFT version Mismatch GTW_w375_RGBRRAFTversionMismatch The vehicle gateway (GTW) detects the Red Green Blue light in the rear right aft (RGBRRAFT) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.
• GTW_w376 — Bl Failed To Exec Boot Img GTW_w376_blFailedToExecBootImg Bootloader failed to execute boot.img
• GTW_w377 — Etherloop Reinit Attempted GTW_w377_etherloopReinitAttempted The vehicle Gateway (GTW) detected an issue and attempted to restart its etherloop subsystem. The reason for this attempt is provided in the alert.
• GTW_w378 — Hvbatt Loop Link Unexpected Asleep GTW_w378_hvbattLoopLinkUnexpectedAsleep The vehicle Gateway (GTW) found that the etherloop link to the high voltage battery (HVBATT) was unexpectedly asleep when it should be active. The GTW reset the etherloop switch to restore the connection.
• GTW_w379 — Etherloop Sleep Interrupted GTW_w379_etherloopSleepInterrupted The GTW was interrupted while trying to sleep due to an unexpected wake-up event on the etherloop switch. The reason for this interruption is provided in the alert.
• GTW_w387 — External Rtc Read Failure GTW_w387_externalRtcReadFailure Gateway time may be invalid. Logs may write to invalid time
• GTW_w388 — Adsp Watchdog Skipped GTW_w388_adspWatchdogSkipped The Gateway (GTW) failed to receive a response to a ping request from the Audio Digital Signal Processor (ADSP). However the GTW successfully received CAN data over Ethernet from the ADSP and so watchdog reset is being skipped.
• GTW_w389 — Rcm Event Detected GTW_w389_rcmEventDetected Gateway has detected a collision event was reported by the RCM (Restraints Control Module)
• GTW_w391 — Adsp Mac Addr Check Failed GTW_w391_adspMacAddrCheckFailed Detected ADSP IP is mapped to a wrong MAC address in GTW's ARP table
• GTW_w393 — Osd Sram Crc Mismatch GTW_w393_osdSramCrcMismatch GTW can not determine if the assets rendered via OSD are accurate.
• GTW_w394 — WIPER version Mismatch GTW_w394_WIPERversionMismatch The vehicle gateway (GTW) detects the Windshield Wiper Motor (WIPER) electronic control unit (ECU) is running a firmware version that may not be compatible with the firmware installed on the rest of the vehicle.