VCFRONT_a304 — Frunk Release Failed

Full alert identifier: VCFRONT_a304_frunkReleaseFailed

Alert description

The vehicle controller did not detect a transition in the front trunk (also known as the frunk) switch states after the frunk latch was commanded to open.

Potential impact

The frunk may be unable to open.

Set condition

The vehicle controller detects that the frunk latch did not transition to the ajar (or secondary) position after commanding it to open.

Clear condition

The vehicle controller detects that the frunk latch transitioned to the ajar (or secondary) position.

Signals to check

These diagnostic fields are associated with VCFRONT_a304. Check the alert's Alert Log in Service Mode Plus for available values.

Signal	Unit
Temperature `VCFRONT_a304_temperature`	degC
Voltage `VCFRONT_a304_voltage`	V

Check other alerts

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of VCFRONT_a304.

VCFRONT_a309 — Frunk Emergency Release Pressed VCFRONT_a309_frunkEmergencyReleasePressed The front vehicle controller (VCFRONT) detects the front trunk (also known as the frunk) emergency release button was pressed while the frunk was closed.
VCFRONT_a389 — Frunk Inhibiting Release At Speed VCFRONT_a389_frunkInhibitingReleaseAtSpeed The front vehicle controller (VCFRONT) is inhibiting requests from the front trunk (or frunk) emergency release button while the vehicle is in motion due to unexpected frunk latch state transitions or conditions.
VCFRONT_a188 — Sleep Failed VCFRONT_a188_sleepFailed The vehicle controller was not able to go to sleep.
VCFRONT_a463 — Frunk Sensor Service VCFRONT_a463_frunkSensorService The vehicle controller detects the front trunk (also known as the frunk) sensor requires service as a condition affecting functionality has been detected on one or more of the frunk latch switches.
VCFRONT_a299 — Homelink Configuration Failed VCFRONT_a299_homelinkConfigurationFailed Homelink configuration does not complete successfully because country code could not be set. This alert is primarily informational and is used for logging purposes.

Browse all VCFRONT alert codes