SSFA_a198 — Sccm Offset Not Calibrated

Full alert identifier: SSFA_a198_sccmOffsetNotCalibrated

Alert description

The Steering Column Control Module (SCCM) steering angle has not been calibrated

Potential impact

Steering performance may be degraded

Set condition

Uncalibrated SCCM steering angle detected

Clear condition

SCCM steering angle calibration detected

Check other alerts

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of SSFA_a198.

SSFA_a192 — Handwheel Not Calibrated SSFA_a192_handwheelNotCalibrated The handwheel has not been calibrated
SSFA_a193 — End Stops Not Calibrated SSFA_a193_endStopsNotCalibrated One or both handwheel endstops are not calibrated
SSFA_a210 — Sccm Overrotated SSFA_a210_sccmOverrotated The SCCM is over-rotated
SSFA_a119 — SCCM MIA SSFA_a119_SCCM_MIA One or more of the messages the vehicle controller receives periodically from the Steering Column Control Module (SCCM) is not received, indicating the SCCM may be unavailable (MIA).
SSFA_a161 — Large Current Offset SSFA_a161_largeCurrentOffset A phase current offset of a steering controller is greater than the expected variance. Steering may not operate as expected.

Browse all SSFA alert codes