SEPS_a198 — Sccm Offset Not Calibrated

Full alert identifier: SEPS_a198_sccmOffsetNotCalibrated

Alert description

The Steering Column Control Module (SCCM) steering angle has not been calibrated

Potential impact

Steering performance may be degraded

Set condition

Uncalibrated SCCM steering angle detected

Clear condition

SCCM steering angle calibration detected

Check other alerts

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of SEPS_a198.

SEPS_a192 — Handwheel Not Calibrated SEPS_a192_handwheelNotCalibrated The handwheel has not been calibrated
SEPS_a193 — End Stops Not Calibrated SEPS_a193_endStopsNotCalibrated One or both handwheel endstops are not calibrated
SEPS_a210 — Sccm Overrotated SEPS_a210_sccmOverrotated The SCCM is over-rotated
SEPS_a119 — SCCM MIA SEPS_a119_SCCM_MIA One or more of the messages the vehicle controller receives periodically from the Steering Column Control Module (SCCM) is not received, indicating the SCCM may be unavailable (MIA).
SEPS_a161 — Large Current Offset SEPS_a161_largeCurrentOffset A phase current offset of a steering controller is greater than the expected variance. Steering may not operate as expected.

Browse all SEPS alert codes