PSFAM_a145 — Eac Status Fault

Full alert identifier: PSFAM_a145_eacStatusFault

Alert description

The EAC status monitor detected a fault due to an EAC status which is inhibited for present system conditions.

This information is not available in the alert reference.

This information is not available in the alert reference.

This information is not available in the alert reference.

These diagnostic fields are associated with PSFAM_a145. Check the alert's Alert Log in Service Mode Plus for available values.

Signal	Unit
Control Flow Inhibit `PSFAM_a145_controlFlowInhibit`	—
Driver Take Over `PSFAM_a145_driverTakeOver`	—
Eac Angle `PSFAM_a145_eacAngle`	deg
Eac Angle Mismatch Fault `PSFAM_a145_eacAngleMismatchFault`	—
Eac Command Angle `PSFAM_a145_eacCommandAngle`	deg
Eac Command Angle Fault `PSFAM_a145_eacCommandAngleFault`	—
Eac Command Inactive `PSFAM_a145_eacCommandInactive`	—
Eac Command Invalid `PSFAM_a145_eacCommandInvalid`	—

Show 8 more fields

Signal	Unit
Eac Command Type `PSFAM_a145_eacCommandType` 0 NONE 1 ANGLE CONTROL 2 LANE SUPPORT CONTROL	—
Eac Monitor Inhibit `PSFAM_a145_eacMonitorInhibit`	—
Eac State `PSFAM_a145_eacState` 0 INHIBITED 1 AVAILABLE 2 ABORTING 3 ACTIVE	—
Eac Status Valid `PSFAM_a145_eacStatusValid`	—
Eac Type `PSFAM_a145_eacType` 0 NONE 1 ANGLE CONTROL 2 LANE SUPPORT CONTROL	—
Eac Type Invalid `PSFAM_a145_eacTypeInvalid`	—
Rear Steer Disabled `PSFAM_a145_rearSteerDisabled`	—
Ssfa Torque Invalid `PSFAM_a145_ssfaTorqueInvalid`	—

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of PSFAM_a145.