EGGREAR1_a202 — Epbm Under I Static

Full alert identifier: EGGREAR1_a202_epbmUnderIStatic

Alert description

Electronic Parking Brake Monitor measured less current than is required for Electronic Parking Brake to transition to PARK.

Potential impact

The caliper may not have the expected holding force.

Set condition

Electronic Parking Brake attempted to transition to PARK while Electronic Parking Brake Monitor had yet to measure the minumum current required to allow the transition.

Clear condition

A new Electronic Parking Brake operation starts.

Signals to check

These diagnostic fields are associated with EGGREAR1_a202. Check the alert's Alert Log in Service Mode Plus for available values.

Signal	Unit
Current `EGGREAR1_a202_current`	A
Desync Count `EGGREAR1_a202_desyncCount`	—
Dyn Apply Allowed `EGGREAR1_a202_dynApplyAllowed`	—
Dynamic Allowed `EGGREAR1_a202_dynamicAllowed`	—
Epb Config `EGGREAR1_a202_epbConfig`	—
Open Allowed `EGGREAR1_a202_openAllowed`	—
Park Allowed `EGGREAR1_a202_parkAllowed`	—
Park Pending Allowed `EGGREAR1_a202_parkPendingAllowed`	—

Show 8 more fields

Signal	Unit
Parking Allowed `EGGREAR1_a202_parkingAllowed`	—
Release Allowed `EGGREAR1_a202_releaseAllowed`	—
Service Allowed `EGGREAR1_a202_serviceAllowed`	—
Start Allowed `EGGREAR1_a202_startAllowed`	—
Unknown Allowed `EGGREAR1_a202_unknownAllowed`	—
Wench Pending Allowed `EGGREAR1_a202_wenchPendingAllowed`	—
Winch Allowed `EGGREAR1_a202_winchAllowed`	—
Winch Release Allowed `EGGREAR1_a202_winchReleaseAllowed`	—

Check other alerts

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of EGGREAR1_a202.