DIRER_a144 — Config Mismatch
Full alert identifier: DIRER_a144_configMismatch
Alert description
The drive interface (DI) or drive inverter (DIx) electronic control unit (ECU) detects a Gateway configuration mismatch with the application currently running on the DI.
Potential impact
The vehicle enters system limp mode and is unable to enter Drive.
Set condition
Set if any of the checked gateway config is not as expected.
Clear condition
Clears when all of the checked gateway configurations are as expected.
Signals to check
These diagnostic fields are associated with DIRER_a144. Check the alert's Alert Log in Service Mode Plus for available values.
| Signal | Unit |
|---|---|
Autopilot
DIRER_
|
— |
Brake Actuation Type
DIRER_
|
— |
Brake HW Type
DIRER_
|
— |
Cabin PTC Heater Type
DIRER_
|
— |
Chassis Sub Type
DIRER_
|
— |
Chassis Type
DIRER_
|
— |
Das Hw
DIRER_
|
— |
Drivetrain Type
DIRER_
|
— |
Show 11 more fields
| Signal | Unit |
|---|---|
Frunk Latch Type
DIRER_
|
— |
Heatsink Type
DIRER_
|
— |
Inverter Hardware
DIRER_
|
— |
Oil Pump 1 Hw Type
DIRER_
|
— |
Oil Pump 2 Hw Type
DIRER_
|
— |
Pack Energy
DIRER_
|
— |
Pack Performance Deviation
DIRER_
|
— |
Performance Package
DIRER_
|
— |
Platform Max Bus Voltage
DIRER_
|
— |
Soft Performance Limit
DIRER_
|
— |
Vdc Type
DIRER_
|
— |
Check other alerts
With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of DIRER_a144.