CC_a028 — CB rotary Select

Full alert identifier: CC_a028_CB_rotarySelect

Alert description

Invalid rotary dial selection.

Potential impact

Wall connector will not operate.

Set condition

Wall connector current limit selection dial is set to an invalid position.

Clear condition

Rotary dial changed to valid setting and unit is power cycled.

Check other alerts

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of CC_a028.

CC_a021 — CB no Master CC_a021_CB_noMaster Wall connector is configured as a slave, but no master was detected.
CC_a023 — CB too Many Slaves CC_a023_CB_tooManySlaves More than 3 units configured as slaves were detected on the sharing network.
CC_a022 — CB too Many Masters CC_a022_CB_tooManyMasters More than 1 wall connector is configured as a master on the sharing network.
CC_a024 — CB master I Set Too Low CC_a024_CB_masterISetTooLow Master unit current limit set too low.
CC_a034 — Boot Alert CC_a034_bootAlert

Browse all CC alert codes